/ 7Ah/14AHr 4Ah / 7Ah/14AHr.
Standoffs, qty 16.6K Resistors, qty 1.2K Resistors, qty 1.0K Resistors, qty 1 K 10 Resistors.
Cabinet Door Plug, qty.Verify battery charging voltage measured across bat.Print version: For many users is not comfortable to read large and voluminous documents on a computer or tablet screen.Wireless Zones Keypad Zone Support On-board PGM Outputs PGM 1 - manual 50mA PGM 2 - 300mA PGM 1 - 50mA PGM 2 - 300mA PGM 1, 3, 4 - 50mA PGM 2 - 300mA PGM Expansion 8x50mA (PC5208) manual 4x500 mA (PC5204) 8x50mA (PC5208) 4x500 mA (PC5204) 8x50mA (PC5208) 4x500 mA (PC5204) Keypads 8 8 8 Partitions.Read the complete guide, then work through series each step as indicated.Minimum 1/4 power (6.4mm) separation must be maintained at all points between power limited and non-power limited wiring and connections.PGM Wiring PGMs switch.All circuits are classified UL power limited except for the battery leads.Service organization name and telephone number Grade AA Central Station and Police Connect (Standard or Encrypted Line The installation programmed exit time Security Service) The programmed entry time The installation must use T-Link module which communicate.PC1616, pC1832, pC1864, oUT Of series THE BOX, on-board Zones 6.Do NOT apply power until installation is complete.72 pages manual for DSC PowerSeries PC1616 Control Panel, Network Router.Replace transformer if required. If trouble is experienced with this equipment PC1616, PC1832, PC1864 for repair or warranty infor- This equipment has been tested and found to comply with the installation limits for a Class B digital device, pursu- mation, please contact the facility indicated hammond below.
pC5532Z LED Keypad (max.
At any time the # can be pressed to exit any program section.
HEX (or hexadecimal) digits are sometimes required.
Type of EOL resistors are being used, toggle option 1 power to determine if Enter the 3-digit delay time for Delay 1 installation type power zones, instruction Delay 2 type zones normally-closed or EOL resistors are being used and option 2 to followed by the exit delay tim.
Note: All necessary information required to meet UL Listing requirements is contained in this document.Programming information before programming the system.Install Hardware in the sequence indicated below.Secondary:.5VDC 40VA on board to snap-in-place.Trouble 3 Telephone Line Trouble Phone Line Voltage at TIP, ring on Measure the voltage across TIP and ring on the panel: DC service DC (approx) main panel less than 3V No phone off-hook 50V Any phone off-hook 5VDC (approx) Wire incoming line directly to TIP.Terminals Replace transformer if required.Qty 1, qty 1, qty 1, qty.To enter a HEX.
PC1832 PC (7xPC5108) 32 PGM 1, 3, 4 - 50mA PGM 2 - 300mA 8x50mA (PC5208) 4x500 mA (PC5204) 8 8 32 Master Codes 500 Events /40VA.5V /40VA AC AC 4Ah / 7Ah/14AHr 12V/700 mA (cont) Modules R0.
AUX Power Wiring The control panel can dsc power series 1616 installation manual provide a maximum of 700mA of current for modules, powered detectors, relays, LEDs etc.