If ohm reading is within this range, the solenoid coil is good.
Motor YEL BLK P2 compressor GRN/YEL RED therm white P3 F1 BLK RJ-11 cable TO comfort control 60 Hz, 1O USE copper WHT BLK conductors owners only Typical Wiring 6204XX.
If the voltages shown above are present, use a jumper wire to test unit operation as follows: This test will by-pass the function of the thermostat.Note: DO NOT use a voltmeter to do therm these checks as it will give erroneous readings.Is a yellow wire and reversing valve - this wire is energized in cooling mode and not dometic energized in the heat pump mode.Remove the terminal cover from the compressor to the three leads connected to the terminals.High cool, jumper wire between GND and FAN, GND and HI FAN and GND and cool.When the liquid enters the low pressure atmosphere of the outside coil (evaporator) it evaporates into vapor.The energizing current will only show through the coil when it exceeds line voltage.FF should appear in the LCD display until the mode and zone push-buttons are released.This will depend upon climate, area, pets, etc.Atwood Water Heaters (1.3 mb suburban SW Series manual Water Heaters, suburban SW series owners manual manual therm (2.2 mb).The controls must be connected to the power source/battery circuit with two wires of adequate capacity to avoid voltage drop.Even after the ambient temperature has gone up, the coils will remain frozen. Units are designed to be installed on flat surfaces or on a slope of dlddh up.
The free area is the opening that remains in a grill or louvered panel after the restrictions are taken therm away.
If the unit is a heat pump, the ambient sensor for the outdoor temperature is plugged into murdochmysteriessekeystoneconstablespweb the red dlddh P3 connection.
Blockages commonly occur in the areas where the duct changes direction.If there is still a problem go to control board testing.The refrigerant which began as a hot vapor, leaves the outside coil as a high pressure cooler liquid.Continuity test section 3 DC Voltage Requirements A murdochmysteriessekeystoneconstablespweb DC volt supply is required for operation of all Dometic electronic controlled units.One end of the cable is plugged into the A/C power module/electronic control box RJ-11-6C4P jack.Heat Pump Operation.The dip switch for zone 2 needs to be turned.When used without the safety owners alert symbol indicates, a potentially hazardous situation which, if not avoided may result in property damage.Set the System Switch (located at the left side of thermostat) to heat pump position.Verify the duct connection at the unit is not leaking into the return air.This air contains large amounts of moisture that will condense on colder surfaces.Control boards.7 Analog Power Module The Analog Control Box comes in 3 different configurations that are not interchangeable.Heat murdochmysteriessekeystoneconstablespweb Low Heat L1,., 1 L1,., 2 L1,., 4 none * none * L1,., 4 none * none * L1,., 4 High Fan Med.XXX RED WHT dlddh BLK BLW GRY T6 T5 T9 T10 compressor BLK BLK T2 T1 FAN motor BLW 3 1 RED K4 NO GRY YEL COM WHT element T8 T7 NOT available ON some models TO furnace faht herm WHT WHT WHT J1 BLK heat.